Parts Inspection and Digitizing Commands
PROBE1 can be used with any axis move to command an interrupted move. The move will be
terminated when an input goes low.
Example: PROBE1 G98 F1 X1.3 Z-2
The X and Z move toward 1.3 and -2 respectively until the probe contacts the part.
PROBE2 may be used with any axis move to command an interrupted move. The move will
be terminated when an input goes high.
Example: PROBE2 G98 F1 X1.3 Z-2
The X and Z move toward 1.3 and -2 respectively until the probe releases from the part.
Note: The input used by the probe commands is selectable in the miscellaneous parameters.